Fiber optic perimeter intrusion detection system kit for fencing

- Fiber optic perimeter intrusion detection system kit for fencing - Consisting of a two-zone controller, a tamper-proof polycarbonate IP66 housing with anti tamper and programming software - The controller provides two protection zones (one on each side) up to 200 meters of detection each by optical fiber - Each zone has independent alarm output - It uses sophisticated algorithms to detect intruders that try to climb, to cut the enclosure or to crawl under the same one - Discriminates false alarms caused by small animals or the wind - Unlike metallic (coaxial) sensors, fiber optics resist hostile environments, such as UV radiation, moisture, saltpeter, etc. - Depending on the length of the fencing of the areas to be covered, the necessary fiber set (sold separately) must be installed: • 75 meters of fencing: Roll of 160 meters OPTEX-109 (RRF-75) • 100 meters of fencing: Roll of 210 meters OPTEX-110 (RRF100) • 150 meters of fencing: Roll of 310 meters OPTEX-111 (RRF150) • 200 meters of fencing: Roll of 410 meters OPTEX-112 (RRF200) - In case of an intruder detected, the controller sends an alert through the alarm relays to turn on lights, surveillance cameras, sirens or to send the alarm to an intrusion switch - It has 2 channels of input / output (one channel per zone) of optical fiber with ST connectors - Fault, event, alarm and power LED indicators - Communication via RS-232 serial port and IP over Ethernet - 2 anti tamper inputs - 2 fault outputs - Operating temperature -40 ° C ~ + 70 ° C - Power supply 12V DC / 24V DC, 3W (250 mA at 12V DC)